Description
Description
- Dual Motor Controller: 5A, 6-18V
- R/C control with servo leads
- Synchronous regenerative drive
- Ultra-sonic switching frequency
- Thermal and over-current protection
- Lithium battery protection mode
The Sabertooth Dual 5A R/C 6-18V Regenerative Motor Driver (R/C) specifically optimized for use in radio controlled vehicles. It is suitable for small robots, cars and boats, and especially well suited for the Antweight and Beetleweight classes of fighting robots.
Out of the box, it can supply two DC brushed motors with up to 5A each. Peak currents of 10A are achievable for a few seconds. Overcurrent and thermal protection means you’ll never have to worry about killing the driver with accidental stalls or by hooking up too big a motor.
Features
- Includes exponential control, autocalibration and built-in mixing.
- The operating mode is set with the onboard DIP switches.
- Synchronous regenerative motor driver
- Thermal and overcurrent protection
- Built in 5V BEC can provide power to a microcontroller or R/C receiver.
- Lithium cutoff mode allows safe operation with lithium ion / polymer packs
- Ultra-sonic switching frequency
- Silent operation.
- Dimension Engineering 2×5 R/C motor controller
- Mounting hardware (2 screws, 2 nuts)
- Quick start Guide
- Example R/C vehicle wiring diagram
- Size: 1.8″ x 1.6 ” x 0.5″
- 45 x 40 x 13 mm
- 5″ (13cm) servo cables
PDF Files
- Dimension Engineering Sabertooth 2x5A R/C Motor Driver
- Dimension Engineering Sabertooth 2x5A R/C Quick Start Guide
- 18g / 0.6oz
- Input Voltage:
– 6V to 18V
– 6-12 cell NiMH or NiCd
– 2s-4s LiPo
– 6V or 12V lead acid (not 18+V lead acid!)
- 5A continuous per channel, 10A peak
Reviews
There are no reviews yet.